I'll tell you, as possible from the ordinary wooden floor or parquet get the perfect trendy white floor, finished color white oil with hard wax.
Wood surface should be covered with no, or varnish, no ground, not impregnated , t. it is. should be an unprocessed. But necessary , board was to grind the grain sandpaper number 120. It is desirable to produce a grinding work before applying the product to our future white floor, as she opens the pores of the grinding timber for a period of about 30 minute , After this time, the pores close again ( because wood – living).
Beginning to make white floor:
Colour White Oil, put on the wood with open pores, impresses by emphasizing the wood structure. If the surface of the wood is chipped or small defects , it is better to putty using a special high-quality adhesives for wood flooring, which has the properties of wood and capable tinted without spot. If our goal is white floor, then plaster are supposed to be white. One can, course to take and putty under natural pine, but you have to look carefully, that this filler (such CLOU) could toned colored oil with wax.
So, after preparing the wood surface, the next step
- We take to the bank, mix well wooden stick, To lift the pigment from the bottom of banks.
- We take very good brush, better with “China bristles” oval or flat, the width of the brush pick up yourself, depending on the surface area.
- Apply the oil liberally brush moves along the grain.
- Give time to penetrate deep into the oil timber minutes 5-15, depending on the room temperature.
- Then a soft absorbent x b cloth carefully wipe the oil from the surface of the wood along the grain movements. Do not be afraid, that will remove unnecessary. This deceptively. The result is a beautiful white wooden floor.
The first layer is almost nothing visually changes, but, Your wood is impregnated with white floor and has an internal protection.
- Through 24 o'clock (least) You can apply a second coat of white oil with hard wax on the surface of bleached floor exactly the same method.
- And after the second layer of wood whitening effect will not be easy noticeable, it will be kind of nice expensive wooden white floor.
You may want to make a third layer of white oil with hard wax, but not before, than 24 o'clock (time for crystallization oil). When applied to a very wear-resistant oil wax Trae Lyx can obtain such a result:
Consumption of white oil for wood (if you take the Golden Wave) is on the 1st layer 20 m². with 1 liters, and the subsequent layers 50 m². with 1 liters. If you use Trae Lyx HardWax Pro Color is the flow rate 30 m². with 1 per liter of coating layer.
White oil with wax on your flooring or just a wooden floor can be applied with a polishing machine.
Here's a little video about applying oil with wax:
You can later change the design a little white floor, give it the effect of antiquity.
This can be achieved by applying the top layer of oil with wax Trae Lyx Pro color “Old-Grey”.
Care for the white floor with oiled wax need a special tool “Care for low-wax” 1/2 cap(60 ml.) Add the concentrated product 5 liters of warm water , this solution to wash the floor 1 times 2 – 3 Week , coverage will be updated, scratches on the cover disappear, and your white floor will become anti-slip effect.